I'm pretty sure this was discussed on a thread somewhere on this site but I can't find it.
Does anyone know what the thread is on the end of the stage 1 gear stick? I need it to get hold of a nylock nut which I can bond into the gear knob and screw it on so it doesn't wobble on me!
Thanks guys.
Gear Stick Thread
-
- Posts: 339
- Joined: Tue Nov 21, 2006 9:45 am
- Location: Wheelers Hill, Victoria, Australia
- Contact:
Gear Stick Thread
Stirling
Videos:
http://www.youtube.com/watch?v=a8Xljp6DD9g 17 June
http://www.youtube.com/watch?v=_mlJblv9iUo 24 May
& Others!
Videos:
http://www.youtube.com/watch?v=a8Xljp6DD9g 17 June
http://www.youtube.com/watch?v=_mlJblv9iUo 24 May
& Others!
-
- Posts: 339
- Joined: Tue Nov 21, 2006 9:45 am
- Location: Wheelers Hill, Victoria, Australia
- Contact:
Thanks Alan,
The plan is to do the same like I did to the trasfer case selector. Grind down the peaks of the hexagon on the nut enough so it is still a bit of a tight fit and then just press it in to the knob. That way, if needed it can be pulled out later.
The plan is to do the same like I did to the trasfer case selector. Grind down the peaks of the hexagon on the nut enough so it is still a bit of a tight fit and then just press it in to the knob. That way, if needed it can be pulled out later.
Stirling
Videos:
http://www.youtube.com/watch?v=a8Xljp6DD9g 17 June
http://www.youtube.com/watch?v=_mlJblv9iUo 24 May
& Others!
Videos:
http://www.youtube.com/watch?v=a8Xljp6DD9g 17 June
http://www.youtube.com/watch?v=_mlJblv9iUo 24 May
& Others!