Rialko Bush and pin

hex · Post by **hex** » Fri May 09, 2008 5:43 pm

anyone know where i can get them or a workround ?

Bumpkin · Post by **Bumpkin** » Fri May 09, 2008 7:23 pm

Hiya.
Try this. Just what your looking for.I had hellava job tracking down bits for my Stage 1.Got a spare set. Might get ano.ther
http://cgi.ebay.co.uk/Land-Rover-Railko ... dZViewItem

hex · Post by **hex** » Sat May 10, 2008 10:23 am

is this where you bought your last set from ?

it very expencive im even thinking about getting some railko made ,

found the pins at 16.44 each
http://www.lrseries.com/shop/product/li ... 201&page=2

they havent got the railkos in but are haveing some made just waiting on the price

if i could get them made would anyone be intrested in a set ?

hex · Post by **hex** » Tue May 13, 2008 8:59 pm

Spoke to an engineering firm today they recon the steel is en40b , they charge 35 quid per hour and say they could do around 10 parts per hour , so that would be around £4.50 each including the steel price

.

one set back i don’t have the internal bore diameter and depth ( one i have is badly warn )

any one have one to measure ?

if i can get the sizes i will sell a set ( 2 off ) at cost plus P&P

anyone interested ?

Bumpkin · Post by **Bumpkin** » Tue May 13, 2008 10:29 pm

Hi
I got a new set here.I'll measure em tomorrow.I'll have a set if thats OK.THe steel is probably EN8.
Tel

robert · Post by **robert** » Wed May 14, 2008 5:18 am

@hex
one set please

hex · Post by **hex** » Fri May 16, 2008 8:24 pm

just waiting for the size

also is it a straight bore or is there a taper in it ?

paul