Stage 1 V8

Anyone got a LH exhaust manifold ERC3482?? Managed to snap a piece off mine today

are you in a mega rush for it? (ie need next week or so or can wait a few months)
l have a set of tubular manifolds to fit that l plan to fit in a couple of months time

No real hurry, let me know when your's is available and if i aint located 1 by then al have it off ya. Just out of curiosity what 4 branch are you fitting? I could be tempted down that route if i can find 1 that fits and doesn't cost the earth.

not 100% sure what make the manifolds are, they might be RRC ones. l am hoping they fit with minimal mods to engine bay. they defo fit the block.
they will be getting wrapped as well.
photos to follow when l do it.

I am in the process of fitting performance headers to my engine. They will need some modification to fit however. I will post images of the mods once I get the motor back in. Couple of images below of headers fitted to new motor before the task of getting them to clear engine bay and chassis.

Regards Warrick.


IMG_5535-web by wpalmo, on Flickr


IMG_5574-web by wpalmo, on Flickr

I love a shiny engine on a stand

Is that the Holley carb?

Yes it is. It is a Holley 390 CFM 4 barrel set up with vacuum secondaries. Should suit the 3.9 that it is feeding. Looking forward to hearing the thing with some fuel running through its veins. Should sound good. The headers flow through to a 2 ½ single stainless exhaust for a clean crisp sound. I love the sound of a V8 Series Land Rover in the morning. Couple more images below.

Regards Warrick.


IMG_5582-web by wpalmo, on Flickr


IMG_5540-web by wpalmo, on Flickr